Tar And Chip/Chip Seal/Oil And Stone Paving Services

We provide professional tar and chip paving services nationwide for worn gravel driveways, deteriorated surfaces, and areas affected by dust, rutting, or loose aggregate. Installation applies liquid asphalt and stone aggregate to create a bonded surface that improves traction, controls dust, and stabilizes the driveway. Request a quote today.

What Is Tar and Chip Paving and How Is It Different From Asphalt?

Tar and chip paving is a surface made by spraying hot liquid asphalt and embedding loose stone aggregate into it. Unlike smooth blacktop asphalt, it creates a textured finish with exposed stone for added traction and a more rustic appearance.

Tar and Chip Vs. Asphalt Driveways: Which Surface Lasts Longer?

Asphalt usually lasts longer under heavy traffic, while tar and chip offers lower maintenance and better slip resistance on rural roads and long driveways. The choice depends on traffic volume, appearance preferences, and surface conditions.

Why Is My Tar and Chip Driveway Losing Stone or Looking Bare?

Stone loss usually happens when the binder ages, traffic loosens aggregate, or the surface was installed with insufficient compaction. Bare spots can allow faster wear and may need patching or resealing to restore coverage.

Can Tar and Chip Paving Be Installed Over an Existing Gravel Driveway?

Yes, tar and chip paving can often be installed over a properly graded and compacted gravel base. Stable base material is critical because soft spots and poor drainage can cause premature surface failure.

How Long Does Tar and Chip Paving Take to Cure and Set?

Tar and chip surfaces are usually drivable within a day, but the binder continues settling as traffic seats the aggregate. Loose stone may remain temporarily until the surface fully locks together.

When Should Tar and Chip Paving Be Repaired or Recoated?

Tar and chip paving should be repaired when you notice widespread stone loss, potholes, exposed binder, or drainage issues. Early maintenance helps prevent the base from deteriorating and extends surface life.

How Much Does Tar And Chip Paving Cost?

Tar and chip paving costs typically range between $4,725 and $14,850, with average pricing depending on total square footage, driveway or roadway layout, site access, and the amount of grading or base preparation required before installation. Pricing can also vary based on aggregate selection, existing surface condition, edge treatment requirements, and whether additional stone layers or localized repairs are needed.

Our Service Area

We provide services nationwide, including in the following cities: